Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Lincolnwood, IL
Chimney repair in Lincolnwood usually means working on a 1950s or 60s masonry fireplace that was never designed for thirty years of Chicago winters. We see spalled brick, cracked crowns, and clay-tile flues that have quietly separated behind the chase wall. Sandstone Chimney Sweep handles the full scope: we diagnose the problem, show you the camera evidence, and repair it with specification-grade materials like DuraFlex and HeatShield. Call (833) 589-7835 for a free estimate.
Why Lincolnwood Homes Are Different
Lincolnwood is a fully built-out village of brick ranches, split-levels, and small colonials packed onto tight lots west of the Chicago River. Most of the housing stock went up between 1950 and 1975, which means original clay-tile flues and exterior masonry chimneys that have absorbed sixty-plus years of freeze-thaw cycles. The village’s dense canopy of mature oaks and maples along streets like Pratt and Crawford drops a steady load of leaves, helicopter seeds, and twig debris into uncapped flues every fall. That organic material doesn’t just block the draft. It holds moisture against the flue wall, accelerates creosote buildup, and gives animals a foothold. A chimney cleaning call in Lincolnwood frequently turns into a relining or crown-repair conversation once we get a camera inside. The homes here share a specific anatomy: many were built with a single central masonry stack shared by the furnace and the fireplace. That means furnace flue gases and fireplace creosote run through the same chase, and a “simple sweep” can expose a liner separation or venting issue that affects the whole house, not just the hearth.
Styles & brands we work with
Our Main Lincolnwood Services
Most Lincolnwood homeowners call us for two things: an annual chimney sweep before burning season, and dryer vent cleaning when the laundry room starts smelling warm or clothes take two cycles to dry. Both are fire-prevention services, and both can be done in a single visit.
Chimney Sweep in Lincolnwood
A proper sweep in Lincolnwood is rarely a twenty-minute job. Because so many chimneys here are uncapped or capped with older screens, our technicians routinely pull leaves, seed pods, and squirrel nests out of the flue before they start brushing. We sweep the full height of the flue, vacuum everything from the firebox to the smoke shelf, and run a camera inspection so you can see the liner condition for yourself. If you use your fireplace more than a few times a year, an annual sweep is the baseline. Chimney Sweep in Lincolnwood explains the full process and what we check along the way.
Dryer Vent Cleaning in Lincolnwood
Lint-clogged dryer vents are one of the most common household fire hazards, and Lincolnwood’s older homes often have long, concealed vent runs that make the problem invisible until it’s serious. Lint builds up around the bends, restricts airflow, and forces the dryer to run hotter and longer. We clean the entire run from the dryer to the exterior termination, then verify airflow and check the termination cap. Pairing this with your chimney sweep means two fire hazards handled in one visit. Dryer Vent Cleaning in Lincolnwood covers what we find in these tight older homes.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Lincolnwood
Chimney repair in Lincolnwood is driven by two forces: the village’s postwar housing stock and the Chicago area’s repeated freeze-thaw cycles. Most of the chimneys we work on are sixty to seventy years old, built with clay-tile liners and masonry crowns that have cracked, spalled, or separated over decades. When water gets into those cracks and freezes, the expansion widens them every winter. The result is often a chimney that leaks into the attic, drafts poorly, or vents furnace gases into the home. Our repair team uses professional-grade products including DuraFlex liner systems and HeatShield resurfacing compounds, not consumer-grade substitutes. We find it, we fix it, and we show you the camera evidence before recommending anything. Our full repair scope is described on the Chimney Repair page, and everything below reflects what we see in Lincolnwood specifically.
Chimney Cap Installation
Signs you need it
You’re finding leaves, twigs, or squirrel nesting material in the firebox, or you can see open sky when you look up the flue.
What it costs in Lincolnwood
Chimney cap installation in Lincolnwood typically runs $400 – $800 including the cap, which matches the $395 – $795 range for this service in Cook County.
How we do it
We measure the flue opening, select a cap that preserves proper draft, secure it to the crown with corrosion-resistant fasteners, and verify the draft with a smoke test before we leave.
Chimney Liner Installation
Signs you need it
A camera inspection shows cracked or missing clay-tile sections, or you smell furnace exhaust in the living room when the system runs.
What it costs in Lincolnwood
Chimney liner installation in Lincolnwood typically runs $4,500 – $9,000 depending on flue height and the liner system we specify.
How we do it
We assess the flue condition with a camera, size the liner for the connected appliance, install a DuraFlex stainless liner with proper insulation, and test draft at the water heater and furnace.
Chimney Flashing Repair
Signs you need it
Water stains are appearing on the ceiling near the chimney chase, or you see gaps and lifted flashing at the roofline.
What it costs in Lincolnwood
Chimney flashing repair in Lincolnwood typically runs $350 – $1,000 depending on how much flashing needs to be cut out and replaced.
How we do it
We remove the damaged flashing sections, install new step and counter-flashing with proper overlap, seal the transitions, and water-test the repair.
Chimney Crown Repair
Signs you need it
The concrete crown on top of the chimney is cracked, spalled, or missing pieces, and brick below it is staying damp after rain.
What it costs in Lincolnwood
Chimney crown repair in Lincolnwood typically runs $500 – $1,500 depending on whether we can resurface with HeatShield or need to pour a new crown.
How we do it
We assess the crown’s pitch and thickness, resurface or re-pour as conditions require, and make sure water sheds away from the flue and brick.
What Chimney Repair Costs in Lincolnwood
| Item | Typical range in Lincolnwood |
|---|---|
| Chimney cap installation | $400 – $800 |
| Chimney flashing repair | $350 – $1,000 |
| Chimney crown repair | $500 – $1,500 |
Do I really need a new liner, or can I just keep sweeping?
A sweep clears creosote. It does not repair cracked clay tiles or seal gaps that let flue gases into the house. If our camera shows a failing liner, sweeping will not make it safe.
How often should a chimney in Lincolnwood be swept?
Annually if you burn wood more than a few times a year. The local tree canopy fills uncapped flues with debris that accelerates creosote buildup, so Lincolnwood chimneys often need a sweep even after a light season.
Brands We Service in Lincolnwood
We stock and install parts from DuraFlex, HeatShield, Famco, and Copperfield. These are the product lines specified by certified chimney professionals and restoration contractors, not big-box substitutes. Having them on hand means most Lincolnwood repairs start the same day we diagnose them. See our brands for the full list and why we choose them.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Lincolnwood, IL
| Service | Typical range in Lincolnwood |
|---|---|
| Chimney sweep | $179 – $399 |
| Chimney inspection | $149 – $350 |
| Chimney cap installation | $400 – $800 |
| Chimney cap replacement | $300 – $700 |
| Chimney liner installation | $4,500 – $9,000 |
| Chimney flashing repair | $350 – $1,000 |
| Chimney crown repair | $500 – $1,500 |
| Dryer vent cleaning | $150 – $350 |
In Lincolnwood, prices push toward the upper end of these ranges when the chimney is on a tall two-story tear-down rebuild, the flue is shared by furnace and fireplace, or decades of deferred maintenance require more than one repair. We give an upfront price before work begins, and that number does not move unless we find something new and show it to you on camera first.
Neighborhoods We Serve in Lincolnwood
We work across the entire village of Lincolnwood, 60712, including homes on the tight lots near the river and the larger lots east of Crawford. Most areas are within a 15- to 20-minute drive of our Near North Side shop, so scheduling is straightforward year-round.
- Lincolnwood Towers
- Pratt and Crawford corridor
- East Lincolnwood
- Lincolnwood East
- The area near the Purim Shul and Lincoln Hall
Service Area – Cities Near Lincolnwood
Sandstone Chimney Sweep also serves homeowners directly across the border in Skokie, IL, where the postwar housing mix is nearly identical to Lincolnwood’s. We work in West Ridge, IL for Chicago bungalow and two-flat chimneys, Portage Park, IL for its brick bungalows, and Albany Park, IL for older masonry stacks with shared flues. If you’re just over a village line, call us: the issues are the same, and we know the housing stock.
Serving Lincolnwood, IL — Our Local Coverage Area
We’re based in the Lincolnwood area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Lincolnwood
Most Lincolnwood addresses are within 15 to 20 minutes of our Near North Side location, and we typically schedule within a few days. Burning-season slots in September and October fill up first, so call before the first cold snap if you want a sweep before you light the first fire.
Most routine sweeps, cap installs, and minor repairs do not require a village permit. Larger structural work, like rebuilding a masonry chimney, may need one, and we’ll tell you if your job falls into that category before we touch anything.
Yes. That’s the “two fire hazards, one visit” arrangement we set up for Lincolnwood homeowners. We’ll sweep and inspect the chimney, clean the dryer vent run, and leave you with a report on both systems before we go.
Call (833) 589-7835 for a free estimate on chimney repair, sweeping, or dryer vent cleaning in Lincolnwood, IL. We’ll tell you what the chimney actually needs, show you the evidence, and quote a flat price before work begins.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Lincolnwood Customers Say
"Liner was cracked in two places. He walked me through the repair options honestly, including the one that was cheaper for him and better for me."
— Amanda Hayes"Swept it, capped it, and installed a proper damper. The downdraft smell in the summer that we'd lived with for years is gone."
— Emily Meyer"Thorough sweep and a clear report. He was running late from the job before and arrived near the end of the window, though he did call to warn me."
— Steve Mercer